4" OD X 24" Long

4" OD X 24" LongStandard aluminum intake tubing. 6061T6 alloy . 065 wall thickness. Cuts easily with a hack saw. About 1 1 2 inches on each end goes inside an intake hose (minimum 1 inch). Mill finish (as it arrives at our location from the mill after traveling on a truck and being handled several times) may have minor defects and small scratches, but no dents or major defects. Made in USA.

It will handle 350 F continuous

This reducing insert adapts a 6" ID intake hose to a 5" OD tube

and D10298163

This 6-inch 45-degree intake hose can be used anywhere you need to join two 6" OD tubes with a 45 degree bend

This 45 degree silicone elbow is 3" ID it handles 500 F continuous and is perfect for intercooler/aftercooler applications

Recommended clamps are 94100-0650 on the small end and 94100-0750 on the big end

45HL70R6045L60R55

Comes standard in a mill finish and may have light scratches

This reducing 90-degree intake elbow can be used any place where you are connecting a 6" OD tube and a 5-1/2" OD tube

This hose hose handles 500 degrees F

You install it in the end of the 4

This 22 degree by 4" ID hose is used where a 45 degree elbow is too sharp